Uninterruptible Power Supplies Online UPS 2K User Manual download pdf (Page 21)

(2) UPS Output Connection

The output of the UPS is IEC socket-types. Simply plug the load power cord

to the output sockets to complete connection. Use one cord for every 5A

load.

Model No. Output Socket (pcs)

1K(S)/1.5K(S)/ 2K(S) 8 * IEC320 C13

3K(S) 8 * IEC320 C13 + 1 * C19

The wiring configuration is shown as the

following procedure:

a) Remove the small cover of the terminal block

b) Use 2.5mm

wires for wiring configuration

c) Upon completion of the wiring configuration,

please check whether the wires are securely

affixed

d) Put the small cover back to the rear panel

(3) EPO Connection:

User can select the polarity of EPO, EPO is Normally close as default setting.

 NO

Normally the EPO connector is open on the rear panel. Once the connector is

closed with a wire, the UPS would stop the output until the EPO status is disabled.

Disable the EPO status Enable the EPO status

Connection diagram

Caution:

Do not connect equipment which would overload the UPS system (e.g. laser

printers)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 40 41

No comments

Uninterruptible Power Supplies Online UPS 2K User Manual Page 21