Uninterruptible Power Supplies Online UPS 3K User Manual download pdf (Page 30)

3: Installation and Set-up

3-10 UPS724-01-00 PowerWave 1000 (1-3kVA) User Manual - Dated 26 June 2013

3.6 UPS Setting tool

The UPS Setting Tool is a software

application supplied with the

PowerWave 1000 which enables you

to set-up certain UPS basic

operating parameters and configure

the programmable power outlets.

The operating parameters can also

be set-up from the UPS control

panel, as described in paragraph

3.5.1, but the UPS Setting Tool

provides the only means of

controlling the programmable power

outlets.

In order to use the UPS Setting Tool

you must connect an RS232 serial

cable between the UPS COM port

and computer on which the

application is installed – with the

computer COM port configured as

described in paragraph 2.4.1.

3.6.1 Establishing communication

1. Connect the RS232 serial cable between the computer and

UPS.

2. Turn ON the UPS input supply but DO NOT press the UPS

control panel ON button.

a) The UPS will run through its start-up self tests and then

adopt its

off status.

3. Run the UPS Setting Tool application on the computer.

4. Select the appropriate Com Port in the UPS Setting Tool.

a) A communication link should establish automatically, but

press the Connect button if necessary to force the

connection.

b) The Serial port open and Connected status

messages should appear.

3.6.2 Generating a UPS profile and data file

The UPS settings you apply through this tool can be saved to a data file on your computer for later recall. This

allows you to observe the changes you’ve made over time, and provides an easy way to restore a previous

configuration profile if required. This procedure shows you how to set up a data file for the specific UPS

machine, then generate a configuration data record and access the file to observe the configuration history.

1. In the top right-hand corner of the UPS Setting Tool enter some

unique details to identify the connected UPS.

2. Click the Write button to send the identification data to the UPS,

where it will be stored in memory.

a) Click the Yes button in the Writing?? confirmation dialog.

b) The UPS will beep twice to confirm that it has received the data.

c) Click OK to clear the Transmit OK dialog.

Figure 3.9 UPS Setting tool

LINE UPS LOAD

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Comments to this Manuals

No comments

Uninterruptible Power Supplies Online UPS 3K User Manual Page 30

Comments to this Manuals

Related products and manuals for Uninterruptible power supplies (UPSs) Uninterruptible Power Supplies Online UPS 3K